Line item disappearing on PO when entering PR

[zoricak_marianne]

We have  a strange thing. When using ME21N and bringing a PR into a PO, the line item disappears and an error message comes up: 'Please enter line item greater than 1', however when we manually enter a line item, for example 010, the line item disappears again and gives a hard error.  We've found that if we do ME21N and manually put in line  item 010, THEN the PR number, it is OK and the PO is able to be created.

This has never happened before. What would cause it? Message 06127

Thank you.

[JL23]

There are 2 new KBAs about that message number in service market place

start with this one, the other is more or less redundant

2118406 - Error 06127 Please enter item number greater than 0 when copy or Purchase Requisition item...

[DanGlover]

Hi Jürgen -

We're facing a similar problem.  It seems to be confined to a single material which had been used in requisitions successfully converted to POs before but we cannot trace any change to the material master which might be a factor.  We have found that ME21 (not ME21N) appears to work.

The KBA link returns "Document is not released" - can you pehaps remember what advice it contained?

[JL23]

if the KBA is currently not released then SAP is probably reworking it, so please contact SAP Support directly

[zoricak_marianne]

We have found the issue.  There was an OSS note that needed  to be applied that updated a field in table EINA.  Thank you all for your help.

[kunal_ingale]

Hello Marianne ,

please share the note number so others can be helped if they have similar issue.

thanks

Kunal

[zoricak_marianne]

My apologies OSS note 2118406. Field LTSSF cannot be blank.  This note re-initializes it to 0000. This can also be done at the info record level if the problem is isolated to 1 part number .  It will look blank when you input all zeros into the field, but this fixes the problem.

[kunal_ingale]

Thanks