on 02-18-2015 7:06 PM
Hello experts,
When I tried to copy a model in BPC Administration, the application ends with an error like that: "Specify the package or flag it as a local object"
I'd copy the AppSet from ENVIRONMENTSHELL, but I can't change/copy/create news Models, the dimensions works OK.
Is there some configuration to do before start a development ?
Regards,
Rui Keiti Kikumatsu
Hi,
I need to create a new classic application using BPC 10.1, and I perform a copy of ENVIRONMENTSHELL for my new custom application.
But, when I try to copy using BPC WebClient at the end of steps shows a message like this and the process was aborted "Specify the package or flag it as a local object".
I test a copy of model (RATES, PLANNING), inside ENVIRONMENTSHELL and the same message occurs again.
We had all steps in setup manual.
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Rui,
Have you complete all the steps in the installation guide upto and including activate environmentshell?
You are mixing BPC terms in your question, in BPC 10 and above, we have environment and models, in 7.5 and below we use appset and application.
Andy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Rui,
Kindly check the standard model (cube) are available in BW (RSA1).
If not run UJS_ACTIVATE_CONTENT program.
Shrikant
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
6 | |
5 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.