Skip to Content

Unknown Physical Sample type assign to Future Inspection lot for Result Recording

The physical sample sticker has to be printed before Inspection lot create . Once inspection lot created I have recode Result to inspection point (Sample management) I don't specify Sample Drawing Procedure in the Inspection plan header.

Example : 20 physical sample sticker are printed , only 10 are used. The sample with sticker will be sent to LAB. Inspection lot later on created without Sample Drawing Procedure (because the number of Physical sample can not be planned) The result from LAB will reference the physical sample no. But, I can not record the result the system show error " Physical sample 80000000950 does not belong to current inspection lot 890000000571"

Is SAP Standard support this requirement or I have to do Enhancement?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Mar 17, 2017 at 05:47 PM

    You don't inspect physical samples with 89 inspection lots.

    You use inspection type 15 and SAP transaction QPR5 to create the inspection lot.


    Add comment
    10|10000 characters needed characters exceeded