Skip to Content

Sender JMS adapter frequent connection error with WS-MQ

Hi All,

I have configured many sender and receiver jms communication channels. Some times WS-MQ is down and not running properly so all PI channels are getting error. To overcome this case I have used "create connection on demand" setting in receiver jms communication channels. so receiver channels are not getting connection issues. There is no such option is available to sender jms adapter. So we are getting connection errors if WS-MQ is down. Later even if, WS-MQ is up and running fine also automatic connection is not established by sender jms channels. In this case we should stop and start manually all sender channels. Is there any setting to overcome manual stop and start activity? or automatic reconnection?

Regards,

Ashok.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Feb 05, 2015 at 07:05 PM

    Hi Ashok,

    Check the option "Use Message Listener based Connector" for Sender JMS channel your issue should be resolved.

    Regards,

    Pranav

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 05, 2015 at 07:33 PM

    if message listener based connector option is not available you can try "message Poll job"

    Refer the note -1501724 - JMS Adapter multiple listeners registered with EOIO QoS

    1568551 - JMS Sender channel with message poll job - stops polling

    Add comment
    10|10000 characters needed characters exceeded

  • Feb 06, 2015 at 09:34 AM

    Hi Ashok,

    Please check below Note question 14

    1086303 - XI JMS Adapter and IBM Websphere MQ FAQ

    Regards,

    Praveen.

    Add comment
    10|10000 characters needed characters exceeded