Message In MICN after changing Cycle count

[raviraj_iddya]

Hi ,

I have a doubt and I need your advice.

I have changed the ABC Indicator percentage to 60,30 &10. I have also deleted the D indicator, but there are materials which are having D indicators.

Now when are running the batch input, MICN . Theyre not able to get any materials.

I wanted to know that since I have not maintained D indicator. This has resulted in the system giving an message of no material available for Cycle count.

So, if they maintain the D indicator or remove the D indicator for materials whether they would able to run the batch count.

Thanks,

Ravi

[raviraj_iddya]

So its necessary to maintain all the indicator A,B,C and D which will come total 100.

what happens if we are only maintaining  only A+B+C=100 and in material Master we are mainitaining only A , B and C only and never using D indicator. So, whether we will be able to execute MICN without having any inconsistency

[JL23]

D is not necessary, you can even have just A and B, but they need to make 100

If you have materials with a non-existent CC indicator then you get the message

Check view V_159C: Entry "plant , indicator" does not exist

Message no. M7651

[raviraj_iddya]

I'm saying the scenario which has not actually taken place.

I would like to know whether the deletion of D indicator in OMCO while maintaining the same in Material master will have a problem in creating session .

[JL23]

You initially said you had it done "I have also deleted the D indicator".

You will not be able to execute MICN for this plant, SAP is checking the consistency of customizing and will issue an error message:

Check view V_159C: Entry 1000 D  does not exist

Message no. M7651

As said before, even in material master maintenance you will receive an error message:

The physical inventory indicator D does not exist for plant 1000

Message no. MM241

[JL23]

With this thoughtless deletion of customizing despite of having the values assigned in material master you actually created an inconsistency in your system. And if you change any other field in the material master you will not be able to save until you have removed this cycle count indicator as SAP will check the correctness of all fields when saving.

The selection for cycle count is a frequently asked question, you should search before posting a redundant question. Of course can a session not be created if nothing was selected.

But this has much different reasons than this inconsistency with the D in the cycle count indicator field.

[raviraj_iddya]

I did not take down the message number but the message is as below -

" No Session is Created"

[former_member183424]

Can you please share the message number..