material result recording value not update in batch classification in material document.

[Former Member]

Hi MM/QM expert,

  In coming material result  recording value not update in material document (GRN), i have maintain all required parameter as MICs, class, characteristics.

but still not getting updating value in MIGO document.

any expert's help appreciated in advance.

i need some urgent solution because of client.

thanks & regards,

Amit Awasthi.

[busyaban7 · Accepted solution]

Hi Amit,

Please can you check if "Batch Derivation' is active in your system. To check that you can go to the below configuration nodes -

Logistics - General => Batch Management => Derivation of Batch Data =>

i) Activate Batch Derivation

ii) Define Derivation Events

iii) Maintain Number Range for Derivation Number

Also please can you check "Batch Valuation" nodes in your config setting -

Logistics - General => Batch Management => Batch Valuation => Valuation for Goods Movement in Inventory Management => Activate Batch Classification for Goods Movements in IM

Please can you do a test in your sandbox to analyze these changes. To my understanding MM team colleague would have better understanding on these config setup applicable in your business specific scenarios.

Also, if you are looking for transferring inspection results of MIC into batches, I believe you should also maintain the below config -

Quality Management => Basic Settings => Maintain Settings at Plant Level => Select plant = XXXX => Go to tab "InspLot completion" => Activate batch valuation without material specification.

Thanks,

Arijit

[Former Member · Accepted solution]

Hi Arijit,

First of all many thanks for provide possible settings, actually result recording values updating in 1 plant successfully but in same setting 2nd plant it is not updating. why is happening ? I am not able to find out. everything has been maintained. In spro plant level setting same.

regards,

Amit....

[busyaban7 · Accepted solution]

Hi Amit,

Please can you provide the screenshots for both of your plants in QM setup explained above. To my understanding, both the plants should have this setup active.

Thanks,

Arijit

[busyaban7 · Accepted solution]

Hi Amit,

In case if the above config is same, then please can you also check one more point.

1. If during inspection lot result recording, the MIC is getting valuated (Status = 3) and Closed (Status = 5) for both the plants.

2. MIC is linked to batch characteristics to pass on the results form MIC to batch characteristics.

Thanks,

Arijit

[Former Member · Accepted solution]

Hi Arjit.

    Thanks for all ur input, when we maintained class characteristics in MIC then able to see result recording value in material document.

regards,

Amit.

[busyaban7 · Accepted solution]

Hi Amit,

That's what I mentioned above

Please close this thread if your issue is resolved now.

Thanks,

Arijit