Skip to Content
avatar image
Former Member

PI 7.31 Table SSRVCHANNELATT empty - Java mapping not working

Hello,

I have implemented a scenario on our new PI system that was perfetctly working under 7.00 but now it isn't.

The requirement ist a ABAP mapping that converts any FLAT IDoc to an xml IDoc (Adapter module can't be used by us). I have created the scenario in the integration builder.

Within the ABAP-mapping I make a select of the table SSRVCHANNELATT to read the details of the scenario,

On our new PI system this table is completly empty. So my ABAP-mapping is courseing a dump.

How can I get the values in this table?

regards

Christian

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Jan 15, 2015 at 10:52 AM

    I have debugged the table on our old PI version and found out, that it contains only the receiver port information. So I updated my codeing and deleted the corresponding lines.

    Thank you all for your input.

    regards

    Christian

    Add comment
    10|10000 characters needed characters exceeded

  • Jan 13, 2015 at 08:11 AM

    Hi Christian,

    What is the PI version? If its Single stack (Java Only), then you cant use the ABAP features.

    If its Dual Stack, then you need to migrate the ABAP code and the required lookup entries in the ABAP table.

    Did you try to check / able to add entries manually in the table?

    Please check if the following component is Install & available.

    Refer: SAP ABAP Transparent table SSRVCHANNELATT - SAP Datasheet - The Best Run SAP Run SAPDatasheet

    Last changed by/onSAP 20040518 Software ComponentSAP_BASIS SAP Basis Component SAP Release Created in640 Application ComponentBC-XI-IBC-SRV (B200001505)Services PackageSAI_SERVICES Determine Adapter Configuration

    Regards,
    Azhar

    Add comment
    10|10000 characters needed characters exceeded

  • Jan 13, 2015 at 11:54 AM

    HI Christian,

    Could you share your st22 dump?, something is wrong in your code, may be the table has changed any field and you can not use the same code.

    Regards.

    Add comment
    10|10000 characters needed characters exceeded