Skip to Content
avatar image
Former Member

PI 7.4 - Error in sender agreement - No sender agreement found for , , , , ,

Hello,

we have a interface were we need to use a ABAP-mapping (Convert flat file to xml - idoc, adapter module can not be used). So we need to go for a "normal scenario" and no ICO. The communicaion is FTP -> Flat file -> ABAP conversion -> IDoc-receiver on ECC side.

I have created the scneario like every other one but when I try to receive a file I get the following error:

The needed configuration looks good so far I would suggest:

Seender Agreement looks also good:

I have already deleted the whole scenario and did a full cache reset without luck.

If I use the sender and receiver communication channels in an ICO (wihtout the mapping) the communication is working.

Any ideas what this error is about?

regards

Christian

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    Jan 12, 2015 at 09:38 AM

    Hi Christian,

    I believe you are using Dummy Interface here for ABAP mapping. Are you trying to post the payload directly from RWB or via FTP?

    If FTP then, Is the file getting picked in FTP? Check the CC log..

    Did your Cache refresh worked? Check the current Cache status if its Green...from the error it seems to be related to cache issue....

    As an alternative:

    Did you try to achieve the Flat File to IDOC conversion using FCC and Graphical MappingĀ  (Or Java Mapping) instead of going for ABAP mapping.

    Regards,

    Azhar

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jan 12, 2015 at 01:00 PM

    Thanks to all. I have completly deleted the interface, cleared the cache and did a restart.

    After that I reimplemented the interface and know it is working.

    Regards

    Christian

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jan 12, 2015 at 08:54 AM

    Hi

    If your senidng system is sending flat file from FTP server, then why you are using Idoc interface as a sending interface in the ID object configuration?

    Create one data type , message type and service interface for the flat file in the sender side. Then create a sender agreement from that interface.

    Let me know if you have any doubts.

    Thanks,

    Indrajit

    Add comment
    10|10000 characters needed characters exceeded