Skip to Content

How is NETVAL_FLT calculated in CUHD/CUIT?

Hello,

I have been trying to figure out why NETVAL_FLT has a value sometimes but mostly not.  I cannot seem to find where it can be calculated.

Does anyone know this?

Regards, Dean.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Jan 09, 2015 at 04:04 PM

    Hi Dean,

    Your question is maybe a little too wide.  What scenario are you describing?  That's to say, how is the GTS document being created?

    Thanks for your further information.

    Regards,

    Dave

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Dean,

      Sorry for the delay - I hadn't found enough time to investigate this...

      The NETVAL and NTCUR fields are populated in the Function Module /SAPSLL/PRN_VIEW_GET, in form VALUE_TOTAL_GET (just in case you're interested).

      The values are taken from the original value & currency for the Net Value Duty Type in the header (VALTY = '001').  If no such value already exists in the header, the sum of the items is used instead.

      That Function Module runs during the Incompletion Check and the Message sending, so if you haven't yet checked or sent any messages, the fields will be empty.

      Hope that helps.

      Regards,

      Dave