Skip to Content
avatar image
Former Member

Solution Manager Manged system configuration issue

Hi,

We have upgraded our existing solman 7.0 ehp1 to 7.10,later performed System preparation and basic configuration steps successfully,now we are trying to add managed system which is ECC6.0 EHP7 ABAP stack system.I have not installed Diagnostic agent yet on managed system,will do it at later stage,I have configured most of the steps in managed system but encountered with couple of errors,below error screen print for your reference and need advise on how to proceed further

Present solution manager is on latest SPS12.

Regards

Uday

Untitled.png (99.0 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Jan 09, 2015 at 08:32 AM

    1.Run verification check in LMDB for this managed system.

    2. Refer Outside discovery note once - 1611483

    3. Update host and diag agents and make sure they are running with proper authorizations.

    4. Share the agent logs, EM logs+status and ports are open, for more information.

    Regards,

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jan 10, 2015 at 05:51 PM

    hi  Uday,

    For 1st and 2nd error (the definition of technical system is not correct)

    follow below link

    http://scn.sap.com/thread/3296055 .

    For 3rd : please verify Wily EM is up and running, is yes please check wily parameters are maintained correctly in 5th step  of managed system configuration. Also this is to inform, you will still face errors in configuration check step , as SAP host agent and diagnostic agents are not yet installed.


    For 4th and 5th error (cannot initialize command)  install SAP hostagent.

    Before commencing managed system configuration its recommended to install Diagnostic and SAP  hostagent, then you will not face much errors.

    Regards

    Jaskirat Singh

    Add comment
    10|10000 characters needed characters exceeded

  • Jan 13, 2015 at 02:34 PM

    Hi Uday,

    Outside discovery is done by Host Agent since you not installed DAA the information which to be sent by it is not there hence its throwing error.

    Install the agent and check LMDB the missing data said in error is available for that host.

    And then rerun the configuration.

    Regards.

    Sriram

    Add comment
    10|10000 characters needed characters exceeded