Skip to Content
avatar image
Former Member

No connection to ESR. Only Local Data are Displayed in SAP system


Hi Everyone,

I have issue on SPROXY ESR connection for new SAP SYSTEM.

1) RFC Connection are fine both PI and new SAP system.

2) SLDCHECK and SXMB_ADM connection are good.

3)  SXI_Cache and SICF everything is fine.

Still I am unable to see the ESR in SAP system. Could you please help me on connection issue.

Thanks

Ashok

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Jan 09, 2015 at 06:36 AM

    hi Ashok,

    Please confirm if you have done all the steps mentioned.

    http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/e0ac1a33-debf-2c10-45bf-fb19f6e15649?overridelayout=true

    and after that Please run these reports to check the issue.

    1)

    The address of the Integration Builder must be stored in the R/3 System

    =>Check/maintain with report SPROX_CHECK_IFR_ADDRESS

    The address is taken the from following parameters in the exchange profile (section 'connections'):

    2)

    The HTTP connection of the R/3 application server must function correctly

    =>Check with report SPROX_CHECK_HTTP_COMMUNICATION


    3)

    The Integration Builder server must be running correctly

    =>Check with report SPROX_CHECK_IFR_RESPONSE


    similar issue addressed in below link



    hope this helps.

    thanks and regards,

    Praveen T

    Add comment
    10|10000 characters needed characters exceeded

  • Jan 09, 2015 at 06:42 AM

    Hi Ashok,

    Have you setup Type G connection? Please check following thread for similar issue resolution.

    Test your system connections as mentioned in following:

    Regards,

    Azhar

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jan 09, 2015 at 06:47 AM

    Hi Ashok,

    Create a G-Type RFC connection in ECC system.

    Path Prefix:  /rep

    Target host and Service No. should point to PI System.

    Pradeep

    Add comment
    10|10000 characters needed characters exceeded