Skip to Content
avatar image
Former Member

Number Range in Engineering Record

Hello Gurus,

Please do let me How I can change the number range configuration to be external.As per configuration its set to be internal and its grayed out and am unable to change it to external. What should I do to change it.

Please refer below screen shot.

Kindly advice.

Thanks & Regards

Jo Pz

Number Range.png (27.7 kB)
Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Jan 09, 2015 at 09:55 AM

    Hi Jo,

    Strange but I think if you leave it empty it is going to take external one automatically.

    Best regards

    Tamas

    Add comment
    10|10000 characters needed characters exceeded

  • Jan 09, 2015 at 07:51 PM

    Hi Jo,

    Go to PLM Web UI --> Objects in PLM Web UI -->Define number range in ER and follow these steps.

    Select change interval and do the changes, either by deleting the existing number range or by change the number range, please make sure NR status in mind (in this case its 0) if you NR status = some number, like (NR Status =200) then you can not change the numbers from 000000000001 to 000000000200, so start different number range from 000000000201 to 999999999999.

    So the number range which should be internal and which on is external.

    Hope this will solve your problem.


    1.png (28.2 kB)
    Add comment
    10|10000 characters needed characters exceeded