Skip to Content
avatar image
Former Member

Could not start transport control program tp


I installed Solution Manager 7.1, Windows w\Sybase DB. I've updated my kernel 7.21 EXT (700),  libdbsl, R3trans and TP. I am going through my post steps. STRUST tests just fine. I've run SE06 options, imported the profiles and I am now trying to configure STMS. When I click Save on the Domain pop-up, I receive:

My sapmnt and saploc shares are created. Permissions set the same as a working system.

I can drill down in DIR_TRANS from AL11 just fine.

RSTPTEST shows:

STMS Alert Viewer shows:

The HOST files and Service files are properly maintained.

The RFC's in SM59 test successfully.

Here is my directory and profile

Any ideas would be greatly appreciated.

Thanks,

Diana

Capture.PNG (15.5 kB)
Capture1.PNG (47.2 kB)
Capture2.PNG (152.5 kB)
Capture3.PNG (99.5 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Jan 06, 2015 at 11:59 PM

    This has been resolved by reverting back to an older TP and R3Trans.

    Thanks

    Add comment
    10|10000 characters needed characters exceeded