Skip to Content

BPC 10.1 Embedded stuck at 'Querying available environments'

Hello,

I have an installation of SAP ERP on HANA. I would like to use BPC 10.1 Embedded (i.e. BPC web  / EPM Addin for Microsoft as front-end) on the same system. As per my understanding, you do not need to install the CPMBPC and HANABPC components to use BPC 10.1 embedded only.

I have carried out all the necessary steps for BPC installation and post-installation as per the installation guide for BPC embedded. 

However, when I try to connect to the system using BPC Web, I get stuck at the screen with message 'Querying Available Environments'.

Has anyone faced this issue before and how did you resolve it?

Is it possible to use BPC Web / EPM-Addin for Microsoft without installing the CPMBPC and HANABPC components?

Thanks,

Ninad

BPC SCN post.jpg (20.5 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Best Answer
    avatar image
    Former Member
    Nov 03, 2015 at 01:08 PM

    Hello Ninad,

    If your problem is still not resolved, I invite you to check the following SAP Notes:

    2236676 - BPC NW 10.1 : BPC Web Client freeze with the message
    "Querying available environments"

    2188929 - BPC NW 10.1 Front end does not load since change in
    RSPLS_HDB_ACT

    Best regards,

    Nedra.


    Add comment
    10|10000 characters needed characters exceeded

  • Jan 06, 2015 at 06:40 AM

    Hello Ninad,

    Could you go through the below link.

    http://mswalker.im/?action=view&url=installing-sap-bpc-101

    Regards

    Bhagyesh Ravange

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Bhagyesh,

      I have tried the suggestion in the link.

      Some of the steps in the post-installation for 'Classic' are not possible if CPMBPC component is not installed (e.g. roles with *BPC*, activation of EnvironmentShell').

      I have performed all the steps that are possible as per the installation guide for both embedded and classical BPC.

      Regards,

      Ninad

  • avatar image
    Former Member
    Jan 06, 2015 at 07:59 AM

    Hi Ninad,

    Which steps have you completed in the EPM 10.1 Installation guide?

    Andy

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Andy,

      I have performed steps 2, 3 and whatever steps are possible from Step 5. Some steps in Step 5, as I mentioned before, are not possible due to CPMBPC / HANABPC not being installed in the system.

      Regards,

      Ninad

  • avatar image
    Former Member
    Feb 03, 2015 at 11:38 AM

    Hi Ninad.

    I Have found the decision for 'Querying Available Environments' problem - the reason is in step 5 - defining RFC Destination.

    Add comment
    10|10000 characters needed characters exceeded