Skip to Content
avatar image
Former Member

Module Pool transport issues

I have a selection screen 100 which will be called before table maintenace generator is being displayed. In screen 100 - PAI event i have added a module(highlighted in RED) - Its working correctly in Development System.

When i move this TR to next system -> this module is not apperaing in the next system. But the include asscociated with this module is transported.

I am really confused why this single piece of code is not getting transported to next system. I transported 2-3 times by going to change mode and saving it. Its getting saved in TR, but after transport - the module changes are not coming.

 

 

PROCESS AFTER INPUT.

MODULE z_check_back AT EXIT-COMMAND.
MODULE %_back AT EXIT-COMMAND.

Thanks and Regards,

Senthil

Message was edited by: Matthew Billingham - updated to more meaningful subject

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Jan 02, 2015 at 01:51 PM

    Hi Senthil,

    Check your PF status (SE41) Active or not.

    Hope it helpful.

    Regards,

    Venkat.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Abdul,

      PF status is Active ! I am worried why this single line is not transported to QA system.

      MODULE z_check_back AT EXIT-COMMAND.

      Thanks

      Senthil

  • avatar image
    Former Member
    Jan 02, 2015 at 02:22 PM

    hi senthil,

    change MODULE %_back AT EXIT-COMMAND.


    to


    MODULE module_back AT EXIT-COMMAND.


    and try.

    Add comment
    10|10000 characters needed characters exceeded

  • Jan 02, 2015 at 03:56 PM

    So the problem is that while the include that contains module z_check_back exists, your flow logic is not being transported?

    If that's the case, then the object that has the screen is probably not in your transport - perhaps in another one.

    From the flow logic, go to "Goto->object directory entry". Click on "lock overview". This will tell you the transport that your screen is on.

    Add comment
    10|10000 characters needed characters exceeded

    • 1) Check that the correct object director entry (R3TR...) is in your transport

      2) On import through STMS, there are various options. One of them is "overwrite originals" or something like that.

      If still no joy, please tell me the object directory entry values.

  • avatar image
    Former Member
    Jan 05, 2015 at 07:06 AM

    Hi Senthil,

    Try to rebuild your objects in that specific function group and check the same.

    Regards,

    Vinodkumar.

    Add comment
    10|10000 characters needed characters exceeded