cancel
Showing results for 
Search instead for 
Did you mean: 

Problem while stock posting during UD (Usage Decision)

Former Member
0 Kudos

Hi,

We are facing following problem while stock posting during UD.

We receive material from vendors... make the GR against a Purchase Order... Material goes to quality inspection...we check it and good ones are transferred to unrestricted use stock & bad ones are to blocked stock.

Now during UD we enter the good qty in unrestricted use field and bad qty in blocked field. Once save UD. Good qty moving to unrestricted use but bad qty not moving to blocked stock. still it showing in quality stock....but when I check in material movements 350 movement is happening & Same with Scrap quantity as well( Movement type 553.. what could be the reason...

Check the below case 100 stock received from vendor...tried to do 50 to UU and 50 to blocked stock...

Accepted Solutions (1)

Accepted Solutions (1)

JL23
Active Contributor
0 Kudos

Kunwar Verma, if a material is quality managed with inspection and usage decision (QM) then you cannot use MB1B , you would receive the famous error QA495

, Can you post a screenshot from the inspection lot where we can see the statuses

I actually think it is the inconsistency which is taken care of  with OSS Hot News Note 1930161 - Stock inconsistencies in table MCHB for batches

Former Member
0 Kudos

Hi Jurgen L,

Thanks for your response.Please find the below screen shot for your reference, after posting the usage decision inspection lot.

In Meanwhile i will gothrough note as mention by you.

Thanks,

Ashok

JL23
Active Contributor
0 Kudos

I asked for the status as I had OSS note 837305 - Inspection lot stock cannot be cleared  in mind, and as the screenshot shows: there is no BEND status.

Since these movements are automatic movements from usage decisions and both notes are more QM related than MM I move this discussion to the experts in QM space

Answers (4)

Answers (4)

Former Member
0 Kudos

Hi All,

Thank you for all your support.

Issue has been resolved by implementing OSS note 1930161.

@ Jurgen L : thanks for you support especially.

Thanks,

Ashok

nitin_jinagal
Active Contributor
0 Kudos

Hi,

Both the screenshots belong to different inspection lot. Pl share a screen of 'stock posting log' for the insp lot in question.

ntn

former_member183424
Active Contributor
0 Kudos

Is there any other movement type happens after post the movement type 350 ?

Are you able to see the stock in Blocked stock for any quantity in MMBE ?

You can can double click on the batch number in MMBE.

Former Member
0 Kudos

Hi,

Use t code mb1b and movement type 343 for transfer block to unrestricted stock.

Regards

kkk