on 12-30-2014 9:48 AM
St.Type: Bulk Behavior. Maintained all put away relevant config (St.Type Search Sequence, WPT, Bulk Structure, Bulk Indicator at Whse Product Master). Created manually three storage bins specifying Storage Type, Storage Section, Storage Bin Type.
Received stock via Inbound Delivery, during creation of HU WT, the system throws an error
No values found for the selection
Could not fully determine the destination data.
The system is not proposing the newly created bins. Thanks in advance
Hi Laksmi,
Even if you completed all the settings related to putaway into bulk storage type, I recommend to check the following points.
1. First of all check the message log - /SCWM/TODLV_I - Go-to - Message log. You might get where is the actual issue.
2. Then you can check if the sort sequence is created for new generated storage bins.
3. Also check if the correct HU type and storage bin type combination is maintained in configuration.
4. Check what is putaway rule is maintained for search sequence, warehouse number and WPT combination in configuration.
I think, hopefully these check will solve your issues.
Thanks,
Sandip
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Laksmi,
Would be helpful if you post the error message log screenshot.
Also check GR Process -> Strategies -> Storage bin determination -> Assign Storage bin types to storage types
GR Process -> Strategies -> Storage bin determination -> HU Types -> Define HU Types for Each Storage Type & Define HU Types for Each Storage Bin Type.
These settings are very important for bulk HU managed storage types.
Thanks,
Sandip
Hi Sandip
Above specified config is maintained. But still problem exist with error
No values found for the selection
Could not fully determine the destination data.
Below is the error shown in message log. (XXXX: Storage Type Number)
Storage type XXXX: HU requirement
'Bulk' putaway behavior (storage type XXXX)
No values found for the selection
Thanks and Regards,
Sowntharya
I just tried this scenario in my test system with storage type 0040 which is bulk and with all the required settings it worked fine. Only error got was the entry in the table /SCWM/T337B, but after maintaining the combination for warehouse number, storage bin type, HU type and bulk storage indicator, storage bin automatically got determined. Please check your settings once again or post the screenshot of message log.
Thanks,
Sandip
User | Count |
---|---|
13 | |
4 | |
3 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.