Skip to Content
avatar image
Former Member

Error Source ZXXX ZQ1CLNT200 Does not Exist

Hi All,

We refreshed our Quality system from Production and completed BDLS coneversion.

However, after that for few Data Sources we are getting the error - Error Source ZXXX ZQ1CLNT200 Does not Exist.

Source System Here is ZQ2 and not ZQ1 and same is visible in RSA1-> Source systems. Also in Data Sources, we can see that this Data source is active and connected to correct source system ZQ2.

However when we check the transformation, we cannot see the Data source connected to it - there is nothing connected beneath it.

We have tried running programs - RSAR_NEWDS_PSA_USEROBJ_CHECK and RSDS_DATASOURCE_ACTIVATE_ALL but still its not solving the issue.

Any pointers please.

Regards,

Alok

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Dec 30, 2014 at 08:28 AM

    Dear Alok

    Is this case of only one datasource or you are having problem with all the datasource.

    Make sure that RSLOGSYSDEST this table has ZQ2 source system available in it

    Regards

    Gajesh

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Alok,

      Not much I can help you with, But have you run the restore of datasource. Running BDLS on RSDS table might help you. Also check whether the entries in RSBASIDOC is as per the settings required

      Regards

      Gajesh

  • avatar image
    Former Member
    Dec 30, 2014 at 07:12 PM

    Hi Alok,

    Please try to activate the tranformation. Use program RS_TRANSTRU_ACTIVATE_ALL.

    ALso, as you have mentioned everything shows correct values in Datasource and tables, probably you need a system restart for the changes to affect.

    Regards,

    AR

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Alok,

      You will have to move the TRFN again from Dev. Create a new TR request and add TRFN to it and ,move to Quality .That should solve the error.

      Regards,

      AR

  • Dec 31, 2014 at 05:47 AM

    Hi Alok,

    This is wrong mapping done by Basis during the Copy/Connectivity of Systems.

    Basis should be able to give you the Right solution....the other Alternate is to Transport the DS from DEV.

    regards

    SVU

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hello Alok,

      You can just transport the transformation, since there the system definition is different. Also it should be OK after Transport is moved if not use BDLS again to rename the source.

      Regards,

      AR