Skip to Content
avatar image
Former Member

" DPC PULL CORE Extractor is not available in Alerting Frame work"

Hi All,

In SAP Solution Manager Workcenter --> Solution Manager Administration  workcenter --> Alerting Frame work --> DPC PULL CORE Extractor was In consistent for one of the system, So we deleted that Extractor. I guess it was a mistake.

How to re-create the Deleted DPC PULL CORE Extractor in Alerting frame work for that particular System. I tried from Managed system configuration, Still not able to generate.

Any pointers to resolve this issue.

Regards

Faraz


DPC-1.png (26.3 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Dec 31, 2014 at 04:51 AM

    Hi Sairam/Michal,

    Thanks for your Valuable inputs:

    When I try to perform Technical Monitoring for the affected system,

    While Assigning Templates I am facing below issue, in Figure 1:

    In SLG1 Logs Below error Shows Figure 2:

    Can you please Guide me further, to resolve this issue, waiting for your response.

    Regards

    Faraz


    DPC-2.png (131.3 kB)
    DPC-SLG1.png (17.8 kB)
    Add comment
    10|10000 characters needed characters exceeded

  • Dec 30, 2014 at 12:39 PM

    Hi Faraz,

    Alerting Framework Extractor are related to Technical Monitoring ,Re-do Tech Mon for that particular System

    Regards,

    Sriram

    Add comment
    10|10000 characters needed characters exceeded

  • Dec 30, 2014 at 01:59 PM

    Hi Faraz,

    I would go back to Managed system Config & re run the step 7, specifically extractor setup.

    This will generate a new extractor set up request.

    Once completed, please activate the monitoring for system that is affected  again: solman_setup -> Technical Monitoring

    -> Define Scope --> Select System-> Setup Monitoring -> Apply and Activate.

    Thanks

    Michael

    Add comment
    10|10000 characters needed characters exceeded