Skip to Content
avatar image
Former Member

Target Data in single stack

I did a JDBC to Proxy scenario. I went to SOAP Receiver adapter I configured for ECC. I open the CC, select Channel, click on the Message Log but the payload I see is the sender data in Receive communication channel also..

Is it because of cache problems

The interface is working fine.

So whre can we see data after mapping, the data going to the target side in single stack PI?

I can see in SXMB_MONI of ECC. I am asking about target data in single stack PI

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Dec 28, 2014 at 12:36 PM

    Hi,

    >> So whre can we see data after mapping, the data going to the target side in single stack PI?

    Activate the following in NWA.

       

    NWA -> Configuration -> Infrastructure -> Java System Properties -> Services -> XPI Service: Messaging System ->Properties -> messaging.syncMessageRemover.removeBody = false (by default = true).

    Thanks,

    Sudhansu

    Add comment
    10|10000 characters needed characters exceeded

    • without this setting(syncMessageRemover.removeBody) we can still see the audit log but this setting has no impact on payload visibility.

      So either change the staging property globally in NWA or apply scenario specific logging as shown in the blogs.


  • avatar image
    Former Member
    Dec 29, 2014 at 07:23 AM

    Hi Midhun,

    you would have to use the radio button "Use Scenario Specific Configuration" and then select the option "Store" on Mapping Step (AM)  in the Advanced Settings tab of the ICO to see the Payload after the Mapping in the Message Monitoring. 


    Add comment
    10|10000 characters needed characters exceeded