Skip to Content
avatar image
Former Member

MessagingException: No response available

Hi,

We have synchronous senario from Webservice to Soap senario. we are getting the following error.

inbound message

- < SAP:Error SOAP:mustUnderstand =" 1 " xmlns:SAP =" http://sap.com/xi/XI/Message/30 " xmlns:SOAP =" http://schemas.xmlsoap.org/soap/envelope/ " >

< SAP:Category > XIAdapterFramework </ SAP:Category >

< SAP:Code area =" MESSAGE " > GENERAL </ SAP:Code >

< SAP:P1 />

< SAP:P2 />

< SAP:P3 />

< SAP:P4 />

< SAP:AdditionalText > com.sap.engine.interfaces.messaging.api.exception.MessagingException: No response available. </ SAP:AdditionalText >

< SAP:Stack />

< SAP:Retry > M </ SAP:Retry >

</SAP:Error>


cwhat might be the problem, any suggestiobn would be very useful

  

   Regards


   Debanjan



Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Dec 24, 2014 at 07:32 AM

    Hi,

    I think you are not getting proper response...

    Try to post the same data with soapUi or altovaxmlspy  and test the interface.. if it is ok then it is problem in PI otherwise problem in payload...

    Thanks,

    Sreenivas

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      hi Debanjan,

      It has not related to PI version. Its an opensource tool to post message to webservice.

      So even if you are using PI 7.4 its not a problem.

      thanks and regards

      Praveen T

  • avatar image
    Former Member
    Dec 24, 2014 at 08:28 AM

    hi Debanjan,

    as suggested its always a good practice to use SOAP UI to check what is expected on receiver end and what response are you getting from SOAP request.

    adding to that if  you can install soap UI on ur PI system its best as it will tell you if there are any restriction on your system.

    hope this helps.

    thanks and regards,

    Praveen T

    Add comment
    10|10000 characters needed characters exceeded