Skip to Content
avatar image
Former Member

Transfer control with different over head %

Hello,

We have a requirement wherein standard cost estimate in plant 1 should be picked up in plant 2. we know that it is possible through transfer control. But the problem is in plant 1 overhead percentage is 10% whereas in plant 2 overhead % should be 13%. However through transfer control only overhead with 10% only is getting populated not 13% in plant 2.

Is there any configuration is missing? how to go about it.

Thanks in advance

K.G.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Dec 22, 2014 at 11:12 AM

    Hi

    I think you may use additive cost for difference OHs. But not very sure that this good to use or not, hence suggest to wait for other suggestions or confirmation on this.

    Former Member may give you more help on this.

    Regards

    Rajneesh

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 22, 2014 at 01:01 PM

    Hi

    Is it same material in 2 diff plant?

    Then you can't charge diff OH rate during transfer control because transfer control is for transferring same cost to other plant.

    But can try by taking OH rate dependency OHtype/Plant combination where you can define Plant wise rate

    Test it in your dev ...

    Add comment
    10|10000 characters needed characters exceeded