Skip to Content
avatar image
Former Member

In J1IFR-List subcontracting challans, system showing Zero Quantity pending although Qty is pending

In J1IFR-List subcontracting challans, system showing Zero Quantity pending although Qty is pending at MASOP vendor. After reconciliation of challan, the Qty sent=250 , Qty received= 113. system must show Qty pending = 137. But when we check in J1IF12, Qty sent=250 and Qty received=113. Why J1IFR report is showing incorrect output.

I am facing this problem after Ehp7 upgrade in SAP ECC 6.0 version.

Thanks & Regards,

Neeraj.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

5 Answers

  • Dec 20, 2014 at 07:12 PM

    Hi,

       If the issue came after system upgrade, I would suggest to check for SAP notes (I couldnt find anything relevant for EHP 7) or raise an OSS ticket to SAP.

    Regards,

    AKPT

    Add comment
    10|10000 characters needed characters exceeded

  • Dec 22, 2014 at 05:48 AM

    Are you using the same number ranges for different series group. This can cause inconsistency. Also check table J_1IGRXSUB whether right material documents are attached to your Challan.

    Also refer to these notes which is only applicable for EHP6.

    1753000 - Wrong output displayed for status in report selection-
    J1IFR

    and

    1674607 - Duplicate entries while displaying Annexure IV in
    J1IFR

    Regards

    Binoy

    Add comment
    10|10000 characters needed characters exceeded

  • Dec 29, 2014 at 07:58 AM

    Dear Kumar,

    Kindly implement below note and try.

    Snote : 1753000 - Wrong output displayed for status in report selection- J1IFR



    Regards,

    Karna J

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 24, 2016 at 12:55 PM

    may be issue with EHP 7 upgrade on J1IFR, i am also seeing this issue as not getting material document no. against the QTY in Annexture for previous period, but for current period i am able to get

    Kumar are you getting material document no. in annexture 4 against the QTY received/Reconcilled. for previous periods

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 25, 2016 at 10:34 AM

    Kumar,

             The issue is with Ehp 7 upgrade. After Upgrade screen lay out reports may get problem. So, please implement the note.

    Snote : 1753000 - Wrong output displayed for status in report selection- J1IFR


    Add comment
    10|10000 characters needed characters exceeded