Skip to Content
author's profile photo Former Member
Former Member

QI and MM quality management set up

1) How to check Inspection control status in QI for bulk list of material code at a time,.?

2) How to check Certificate required status e.g. YQ01 for bulk list of material code at a time from MM ?

Add a comment
10|10000 characters needed characters exceeded

Related questions

5 Answers

  • author's profile photo Former Member
    Former Member
    Posted on Dec 10, 2014 at 05:30 AM

    Hello,

    Use QA08 for mass activation of Inspection type.

    Use MM50 for mass update of required certificate type in MM

    Regards

    Add a comment
    10|10000 characters needed characters exceeded

  • Posted on Dec 10, 2014 at 05:43 AM

    Inspection set up you can check in mara table..........maintenace status field 'KDELBQSVC'.

    Certificate in qa33

    Add a comment
    10|10000 characters needed characters exceeded

  • Posted on Dec 11, 2014 at 08:03 AM

    Hi

    For

    Inspection control status - check Table / Field QMAT /CHG

    Certificate required status(QM Control Key) - check Table / Field MARC / SSQSS

    Add a comment
    10|10000 characters needed characters exceeded

  • Posted on Dec 10, 2014 at 12:32 AM

    Hello Avinash,

    Please check transaction QA08, it may help you in this.

    Regards,

    Ayoub.

    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Dec 12, 2014 at 10:59 AM

    Hi All

    Can i change the Inspection Control in QI in mass

    Add a comment
    10|10000 characters needed characters exceeded

    • HI

      If you are asking about Control Insp Lot setting- Yes it is possible.

      1. If your existing setting is based on Inspection Type then do config change at Quality Management -->Quality Inspection ->Insp Lot Creation->Define default Values for Insp Type

      2. If it is based on Material (Different control setting with in Insp Type) then create New Inspection Type for each control setting by copying the existing Inspection Type and keep the required control setting. Assign the new Inspection Type to the Material with QA08.

      Hope this will do....

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.