Deleting extra groups in MMNR - A stadard SAP way.

[Former Member]

In MMNR, i got few Junk groups, There i can not found any way to delete those Junk Groups..

Is there any way to delete them..

There was solution in SCN to run the  program 'RSSNR0T1' ...but when I run the program system ask for access key which is not at all the way should to do.

How to delete these junk groups in MMNR?

No a clear cut answer on SCN previously ,hence I have put the question again. There must have some standard sap way to delete them.

Please guide.

[JL23 · Accepted solution]

I doubt that there is no clear answer. I rather think you do not like the answers.

If you look into OSS note 545211 - FAQ: Material master Customizing

then it is clearly said: "If there is a "Group without text" comment in the group display (Customizing transaction MMNR), you should use the report RSSNR0T1."

[Former Member · Accepted solution]

Dear Jurgen,

I have run this above programme thru se38, system ask for access key

Will you please tell me, becoz access key has to obtained from the SAP & for this change I dont think this might be the case.

Please suggest if am going wrong.

[JL23 · Accepted solution]

Are you clicking execute or did you click the change button?

try it from transaction SA38

[Former Member · Accepted solution]

Dear Jurgen,

Yes I got the desired result,

I am making mistake of running the said programme in 'SE38"...but you told the eureka of "SA38" which nobody had told earlier. Everybody asking to run the program in SE38 but not pin pointed this in all previous thread.

Thank You so much sir.

( I like to understand sir that where SAP has mentioned this procedure as a user SAP must have mentioned this information at prominent place which I got thru you only!!!!)

[JL23 · Accepted solution]

there is no prominent place, I just recommended SA38 because it does not offer all options of SE38 , hence less option to make errors.

[Former Member · Accepted solution]

Thank You Sir.

[Prasoon]

Hi Atul,
   Refer the KBA: 1957773 - "Error in structure of group table, cannot be copied" when maintaining number range which explains with screenshot, how to execute the program.

   I think its due to wrong procedure only. It should ask for access key if you are trying to edit it - Not while executing. Please check and revert back.

Regards,

AKPT

[Former Member]

Prasoon,

Thanks for your reply,

SA38 did solve the problem.