IDOC interface is not complete in MATMAS

[Former Member]

Hi

I am new to ALE and trying to transfer material between two clients in the same BOX through MATMAS.

I am sending material through BD10 and IDOC is properly sent to receiving system. But on the receiving side I am getting the error message 51 whose reason is as follows

"The IDoc interface is not complete for message type MATMAS".

In the sending system receipients partner profile is maintained as follows.

Outbound partners grid

Message Type

MATMAS

SYNCH

Inbound partners

Message Type:- MATMAS (Process code is MATM),

Partner Func:- LS

Earlier I was getting the message "Function module not allowed: AFS_RETAIL_ARTMAS_IDOC_INPUT" but I have corrected the error by maintaining the correct FM assignment in WE57. (FM processing is set as "immediately triggered" in partner profile attributes)

Please advise me where I am wrong

[Former Member]

Hi Saurav,

Check out these posts.

Hope these help!

cheers ,

Prashanth

[Former Member]

Hi Prashanth

Thanks a lot for the response. I would try it through RBDMIDOC and revert back. Supposing it runs that way I would still be buffled at its failure at automatic execution.

Regards

Saurav

[Former Member]

Oops, forgot to mention that both the clients are in 4.6c