cancel
Showing results for 
Search instead for 
Did you mean: 

Reg. Inspection Lot status SPRQ Missing

former_member305655
Participant
0 Kudos


HI All,

I have an issue in QM where i do GR against Purchase order and Inspection lot created.

My setting in the material master are QM view are

1. Inspection type - 01

2.Post to Insp. stock - Deactivated

3. Automatic Assignment - Activate

4. Automatic UD- Checked

5. Skip Allowed - Checked

6. Check Chrs- Checked

7. Control inslot- For Each Material, batch and SLOC

When i did GR Insp.lot created and material doc posted with 101 movement and posted the stock to unrestricted.

Now i see the system status of my lot as LTCA CHCR CTCM

and user status as - NSPO

For some reason I see the lot is cancelled.

My question here is

1. If lot is cancelled means the the STATUS SPRQ will not be displayed? Is my understanding correct.

2. If I reset the lot cancellation will I get back the SPRQ status?

3. In which case does this status SPRQ will displayed in the lot? Is there any config in place.

4. Currently i notice the batch stock is not available in system anymore.

5. How do i check the lot cancellation material document

6. I don't see any UD for my lot. I hope the lot got cancelled before UD so that SPRQ status is missing is that right?

7. What needs to be done to bring back the status SPRq for the lot?

Regards,

MBN

Accepted Solutions (1)

Accepted Solutions (1)

anand_rao3
Active Contributor
0 Kudos

Hi, I try to answer sequentially!

  1. Yes
  2. Yes - But resetting the LTCA status means you should cancel the movement type 102 which set the status to LTCA.
  3. SPRQ status is generally displayed when you tick on post to inspection stock in material master. SPRQ stands for stock posting required
  4. Batch stock means what? Whether the material is batch managed? Probably the stock must have been consumed or reduced from inventory as a result of GR reversal.
  5. Go to QA03. Put the lot number and then click on Material document tab. You can also check in QAMB table
  6. Yes. Cancelled lots do not have UD code.
  7. Either you should cancel the 102 material document that caused LTCA stauts (generally when you do 102 movement or cancel 101 movement then it sets the lot in to LTCA mode) or you can carry out fresh GR. I would suggest if you want SPRQ status - It means that you want to do the stock posting through QM. So you should tick on post to inspection stock.

Anand

Answers (0)