Unable to save new Entries in SPRO

[Former Member]

Hello Experts,

I have a requirement to save new entries in "Define Doc. Type Cat. for Consump. Billing and Final Billing" config. I have saved 5 entries which are available in Standard system and apart i want to save two additional entries which i am unable to save, please assist me in saving this requirement.

What i mean to ask in above SPRO level is i will explain below,

I have saved in my present system

DCat    Text                                          Doc. Type

01        Consumption Billing                  CB

02        Final Billing                                FB

04        Simulation                                  SI

05        Manual Billing                            MB

These are available in Standard Document Type Category, but i am also trying to save below entries which i am unable to save.

06        Manual Billing (Backbilling)        MN

07        Manual final Billing                    MS

where as i have seen in few projects same above two entries have been saved, which i am sharing in below attachment for your reference.

Please assist me in saving 06 and 07 entries and help me in saving the same.

[AmlanBanerjee]

Hi Kushal,

Are you getting any error while saving the last two entries for documen type categories 06 & 07.

As per the standard SAP recommendation, you should only allcoate a different document type to each document type category.

Thanks,

Amlan

[devashish_bhattacharya]

Hi Kushal,

What error are you getting?

Please try maintaining it by going to SM30 > TE667.

Regards,

Devashish

[Former Member]

Hi Amlan Jee,

But as my previous project, they were able to save those extra entries as shown in attachment.

[Former Member]

Hi Devashish,

I tried and unable to save through SM30. I am getting Enter a Valid Value error in my system.

Thanks

Kushal

[william_eastman]

If your system has only has 01-05 values for domain blartyp, then you cannot enter more values in the table, and the programs shall not be able to use other values.  since the programs cannot use the values, then config entries will not be of value.

[Former Member]

Hi Will,

Yes even i accept, but as shown in my attachament of previous project, they were able to save data.

Thanks

Kushal

[AmlanBanerjee]

Hi Kushal,

I think what has been done in your previous project is you have enetered the document category values at the domain level.

Go to table DD07L and give the domain as BLARTYP and in there you can mainatin the document type categories.

Once you have maintained the above, you can see them in the SPRO configuration.

Hope it helps..

Thanks,

Amlan

[Former Member]

hello,

I saw there are a list of billing type , so anybody can advise me how to execute Manually Billing in FICA?  thanks

Regard

Mary