on 11-07-2014 5:55 AM
Hi,
I have a question regarding delta job fail in 3.x flow.
What steps to be followed when delta update fails while loading transaction data in dso (Source is ECC)
let me know if you need any other information from my side
Thanks
Hi,
if delta failed make ti red again the trigger the info pacakge.
first time delta failed?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
if problem at PSA only you are steps are correct and follow the same every time when your request fail because of bad/invalid data or wrong data format.
if you face source system error related then you need to follow separate steps.
in case of delta failure we need to run repeat delta once the correction was done at source side.
Thanks for the last piece of information
When you say source system error, what kind of message am i looking for? how am i going to understand that it is a sorce system error
When you say repeat delta after correcting the problem in source,
I need to again follow the same steps as mention above( turn request red in target, delete and update schedule)
Thank you all for replying to mey post. I have other questions which i will post in a seperate thread.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
When it was failed, After the delta fail, have you trigger your delta load again?
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
25 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.