Error while uploading Intital Stock in EWM

[Former Member]

Hello All,

I am getting error while uploading Intial Stock in EWM via Txn code /SCWM/ISU.

below is the error " Prodcut XX does not exist " You can see the Product Warehouse data is maintained.

Let me know if anybody can help me here.

Thanks

[Former Member]

HI Inderjit

PAK is internal unit of measure system uses for PAC. You should use PAK in your upload file in place of PAC. Check out SPRO> SAP netwever > General settings > Check unit of measure you will know.

Best Regards

Phani sai MN

[Former Member]

The same error still persists even if i try giving UOM as PAK in upload file

[Former Member]

Hi Inderjit,

Can you try to change as PK in upload file and try to upload.

Regards

Suraj

[Former Member]

Hi Suraj,

Tried with PK , error still persists.

Thanks

Inder

[Former Member]

Hi Inderjit

Check table T006 ISOCODE Unit of measure and find out issue.

also compair same entry with ecc T006 table.

you can use scmp tcode.

Also Try to create same mat manually and check if you get some clue of actual error.

Regards

Suraj

[former_member600986]

Hi Inderjit,

At first glance at the screen shot seems the systems is looking for unit of measure "PAK" whereas the load file and material master have PAC as UoM.  Did you investigate why so? 

Thanks,

Faical