Skip to Content
avatar image
Former Member

NWBC issue


Hi Folks,

I have done the configuration for ARA in GRC system.After executing the jobs, the data(users and roles) reflects in the relevant tables in GRC system from the back end(traget) system.However, when I am trying to perform user level simulation via NWBC, it does not show any users or roles for the selected connectors.

Please let me know that what might be the solution for my issue.

Thanks and Regards,

Antargami Gauda.

ARA_issue.JPG (85.4 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Oct 29, 2014 at 10:10 AM

    Hi Antargami,

    beside the recommended steps above did you check SLG1 if there is any log available?

    Regards,

    Alessandro

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member


      Hello All,

      This issue is resolved.The resolution is that please ensure that the RFC connector name from GRC to target system is same as the logical system name in BD54 of the target system.

      After correcting the RFC connection name,I re-ran the jobs and now i can find users in NWBC.

      Regards,

      Antargami Gauda.

  • avatar image
    Former Member
    Oct 29, 2014 at 09:48 AM

    This message was moderated.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 29, 2014 at 09:56 AM

    Hi,

    Through which technique you are updating Data ..?

    Regards

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Shashank,

      My issue is that before simulating, at user level in NWBC, i select the required system and then when i try to select any user for user simulation, user does not reflects.

      I hope now you understood my exact issue.

      Regards,

      Antargami

  • avatar image
    Former Member
    Oct 29, 2014 at 10:04 AM

    Hi Antargami,

    Make sure that you have ran Full Repository sync for User/Role without any error.

    You can find the user entries under table GRACUSER which is a master table for user data and Table GRACUSERCONN which contain the connector specific entries.

    If the user is there in these tables then it should come in F4 search.

    Regards,

    Shaily

    Add comment
    10|10000 characters needed characters exceeded