Skip to Content
avatar image
Former Member

Results cannot be entered

Hi all,

When recording results for inspection lot, for one MIC the "Result" field is grayed out,

I want to enter mean value as measured results but not possible

Here you can see the control indicators for this MIC

Please tell me how to configure this. Many thanks.

Regards

Danny

Untitled.png (12.3 kB)
Untitled1.png (9.4 kB)
Untitled2.png (15.2 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    Oct 27, 2014 at 05:26 AM

    Hi Danny,

    Check if this is a calculated characteristic.  You didn't attach the screen of the second screen of control indicators.  There is an indicator 'Calc. charac.'.  In the tab 'Quantitative data' of characteristic details, you can maintain formulas.

    In this case, the characteristic result is calculated by the inputted formular and not intended for manual input.

    Br,

    Nancy


    Add comment
    10|10000 characters needed characters exceeded

  • Oct 24, 2014 at 09:00 AM

    Hi Danny,

    Pl. check the Lower - Upper and Target values set for the MIC. There seems to be some error in it. Regards, KrishnaM

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 24, 2014 at 11:13 AM

    Hi Danny,

    Why you have selected 'Lower specific limit', 'Upper specific limit' and 'Check traget value' in MIC control indicators. Try to deselect 'Check traget value' and check again.

    Also check if any DMR is used for the MIC in inspection plan.

    Please share whether this helps you.

    Best Regards,

    Gururaj Kulkarni

    Add comment
    10|10000 characters needed characters exceeded