Is it possible to automatically launch LT06 after posting change in QM t-code (QA32)?

[Former Member]

Hello

I know that is it possible to config automatically launch of LT06 throungh option "x" in OMKX but I believe that is just for postings done only through MM t-codes (MIGO, MB. etc) does anyone know how could i fix the same procedure for QA32 movement type 321 f.i????

Please let me know ASAP...

[MANIS · Accepted solution]

Standard SAP - QA32 is a QM transaction to select the inspection lot and perform the usage decision once you perform that system creates Posting Change Notice(PCN)  and the transaction LT05-Create TO against PCN run in background to create a TO to transfer the stock from Quality to unrestricted,

I don't see use of LT06 - Transfer order against material document, why do u want to call LT06 in background

[Former Member · Accepted solution]

Not in backgroung I would like to have an automatically launch of LT06 screen once they have posted the movement from QM t-codes as it is possible from MIGO for example..

[MANIS · Accepted solution]

Still i am not clear why do u want to call LT06 whereas during Quality decision system calls LT05.

Please find below the setting where we define the setting whether system should call the LT06 screen or create Transfer order in background. This setting is at warahouse + ,material level (in the below example if you will set X then system willl always call LT06 screen upon material document creation)

LE------WM---------- interface------Inventory management ---------------Define movement type

[Former Member · Accepted solution]

Yes I know this config, but the problem is that they perfom movement 321 through QA32 (which is not a MM t-code) so the LT06 does not launch automatically after posting 321 in QA32 as it happens in MIGO t-code. Neithere there is a way to automatically config LT05. They want to do OT manually not in background but in order not to forget doing TO they want the LT06 or LT05 screen automatically launched......

[former_member197616]

Have you checked moment type settings for a Z oNE ?