on 10-01-2014 2:39 PM
Hi experts,
I created a new flatfile data source, i would like to transport in an active version and avoid any manual actions or activation via program in targets environments.
I collected the concerned data source into a transport order as following:
Is that sufficiant or do i need to do other thing to be sure that this data source will be active.
Thanks.
Amine
Thanks guys.
Amine
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Amine,
Also collect the Info package of that flat file data source in same TR.
Regards,
Abdullah
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
you want transport the only data soruce above request is sufficient.
have you created traget and transformation you need to collect if you want.
but target system flat file should be same technical name sync with the dev system.
please seach on my content i worte the transport docments.
Thanks,
Phani.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
If you collected active data source from dev system then that's enough.
Assuming as Flat file source system was setup and active at target systems.
The fields/info obejcts which you used in your data source will be exsit at target system.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.