Skip to Content
avatar image
Former Member

Rules are not satisfied for Employee ID - HR Trigger

Dear All

I am Trying to configure the HR trigger functionality & encountered the below issue.

1. Followed "GRC 10.0 - HR Trigger configuration" completed the BRF+ config.

2. When i Hire an employee in the HR system - i am receiving logs in the SLG1 (GRC box)

3. when i open the log at the end i see "Rules are not satisfied for Employee ID 00000038"

4. When i try to perform the debugging using the wiki link "Debugging HR Trigger - GRAC_HR_TRIGGER_EVENT_RECIEVER"

i get result screen as attached.

Note: In debugging mode - the steps are not the same as shown in wiki document.

Pls let me know how to handle this situation

Raju

HR Trigger.png (68.6 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Sep 29, 2014 at 12:30 PM

    Check you decision table again.

    check SLg1 logs and see what attribute is triggered and are they maintained in your decision table.

    Regards,

    praasnt

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Naveen/Prasant,

      Any idea what could be wrong here as I am still getting Rules are not satisfied error. Please help.

      Thanks,

      Pawan