on 09-24-2014 10:26 AM
Hi,
In Dev system DTP is inactive. When click on edit button it showing below error message.
Message no. RSBK260
A transformation (0R1295N6W3CDAGBYMXVIOR2VKYO6SD62) used by the DTP is inactive.
The action (request processing or DTP maintenance) was terminated.
Activate the transformation. It connects the source 0HR_PT_2 LS_HRD100 to the target ZPT_C01
But transformation is active only. Please help on this.
Thanks,
Manjunatha
Dear
follow below link
https://service.sap.com/sap/support/notes/948976
Recheck your transformation and entire data flow again with the RFC/source system connectivity.
hope it helps and clear
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear
you proper check each and every rfc go to sm59
open particular rfc goto utilities check for authorization test and connection test both should be clear if problem presist in authorization that is password issue you might change some password give correct
username and pass then it will go further check and let me know
Regards
Hi,
Did you tried with creating new DTP and activate it? Is it delta DTP or Full DTP. Only one DTP u r not able to activate or alll DTPs u r not able to activate?
Thanks and Regards,
Bharath Reddy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please activate the entire flow starting from the target, then source, then the transformation and finally the DTP.
Regards,
Arminder Singh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Tick mark the option 'USE M version of DTP (if Available)' while executing the program RSDG_TRFN_ACTIVATE.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Manju,
May be your transformation is active but not executable.
Please activate your transformation again and then activate your DTP.
You can also use the program RSDG_TRFN_ACTIVATE to activate your transformation.
Regards,
Ashvin
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
What is source and target for your dtp?
Source and target objects are active?
Reactivate your transformations
Later you can activate your dtp and see.
if not corrected then do the repair the dtp thru program - RSBKDTPREPAIR.
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Above programs belongs to dtp.
But your issue in transformations.
is those standard transformations or custom one?
Mean while can you check RSLOGSYSMAP table in bw.
whether its have source(ECC Dev) and target(BW Dev) names.
if not there then maintain them with help of basis.
later you can activate transformations.
Next create dtp ,save and activate.
Thanks
Hi,
relicate the data source 0HR_PT_2 form ECC.
Aativate the cube -ZPT_C01
about tranformation is it custom transformation or standard content tranformaiton?
if standard install the same transformation then activate.
if custom check the any ABAP logic for syntax errors.
above all checks it completed activate the transformation through program- RSDG_TRFN_ACTIVATE
Thanks,
Phani.
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.