SAP PI 7.40 Dual Stack - Proxy Connectivity

[Former Member]

We are on PI 7.40 dual stack and I would like to use it as a single stack for all the interfaces except for ccBPM scnearios.

I have done the configuration (create RFC destinations on ECC (SM59)) as per the blog below.

Completed the configurations for an outbound proxy from ECC to JDBC scenario in ID using ICO.

When I trigger an outbound proxy message, I get the error "Error Parsing PI message" on SXMB_MONI of ECC.

Am I on the right track?

[Former Member · Accepted solution]

Hi Naveen,

Please check your Receiver Component correct or not?

Regards,

Ravi

[Former Member]

The issue was resolved. Message protocol on the SOAP sender channel had to be fixed.

[engswee]

Good to hear that. Please close the thread.

[engswee]

Hi Naveen

Can you try adding the module parameters as mentioned in page 8 of the document below and retry?

Although the document is for PI 7.11 and it says it will be defaulted in future releases, it might be worth a try as it is also stated in OSS note 1349125.

If it does not work, please provide the details as Hareesh mentioned above.

Please also avoid cross posting - creating multiple threads for the same issue at the same time. Forum members who reply to one thread might not be aware of answers posted by others in the other thread. Please close the thread below:-

Rgds

Eng Swee

[former_member184720]

Can you share complete error message?

Also did you notice any error message under PI Communication channel?