Skip to Content

Low Buffer in ST02

Hi All,

Upon fresh installation of ECC 6.0 EPH7 and then I did a client copy, but upon checking ST02, it seems most of my buffers are low not close to 100 at all (Screenshot below).

I tried to play around with

rsdb/ntab/irbdsize

rsdb/ntab/entrycount

to tweak my initial records but still very low and does not seems to improve,

any steps where I should start beginning to troubleshot?

Thank you,


Regards,

Ura

Buffer_No_good.JPG (104.7 kB)
Buffer_No_good.JPG (104.7 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Sep 16, 2014 at 07:44 AM

    Hello

    HitRatio are not significant after a system restart.

    Here you've got low ratio but few DB access, buffer HitRatio should improve with user activity.

    1918603 - High swaps in transaction ST02

    It is not possible to suggest a precise value for the buffer sizes. The sizes depend on the update

    level, amount of data in the system, the applications used, etc. In general, the buffer must always be set

    as large as necessary to avoid swaps.

    Regards

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 16, 2014 at 08:55 AM

    Hi

    this depends upon following parameters

    1. what is the concurrent user activity in ECC

    2. what is the size of buffer

    3. what is size of DB Buffer and DB block size .

    and yes agree with Yves that this Ratio will increase as system is getting used by users and more activity done in system and only need to take care is to check all memory parameter in sync with your hardware and DB.

    Regards

    Dishant

    Add comment
    10|10000 characters needed characters exceeded