Skip to Content
Former Member
Sep 15, 2014 at 11:06 AM

Design Studio - automate table width dependingly to the number of dimensions



I use DS1.3 SP01 with IE11.

In my scenario from a click on a pie chart with Key Figure, I open a crosstab where a user sees some details (only characteristics).

Also, via a bottom, user can open a filter panel, in order to add some additional free characteristics to the details tab, in rows or columns, if needed.

Problem, already seen by others => no vertical scrolling seems to be available, if our tab is not large enough in design.

I don't want to specify a width to 1000(or similar), as suggested in above threads, because our user can add about 10-12 char, so without flexible width, it is not a good solution for us.

Is there anybody who tried to calculate a number of dimensions (columns), taken from a datasource, in order to pass this number as a parameter of method setWidth().