Run Time Error while loading master data from BW to BPC:MESSAGE_TYPE_X

[Former Member]

Hi Experts,

When I try to load master data from BW Info object to BPC Dimension, I am getting a below Run time error. Could you please help me in resolving this issue.

Thanks & Regards,

Ramesh.

[Former Member · Accepted solution]

Hi VaraPrasadraju/Ganapathi,

Status of the Object "/B28/YFBD2JTI" is active only. However, I have activated this object once again and ran the Data manager package which ends with same run time error which I have pointed above.

Finally, I have deleted all the master data from BPC Dimension and ran the data manager package again. This time package ran without any issues and data is loaded properly into BPC Dimension.

Issue is resolved. But I am not able to understand what is happening in the background. If you have any ideas about this, please share it.

Thanks & Regards,

Ramesh.

[former_member229290 · Accepted solution]

Hello Ramesh,

You can find an explanation in SAP KBA: 2012666 - Dump MESSAGE_TYPE_X during master data transport

Best Regards,

Noura

[Former Member · Accepted solution]

Hi Noura,

Without deleting and reloading the master data, I have resolved this issue using the steps given in the SAP note shared by you. Thanks a lot for sharing this document.

Thanks & Regards,

Ramesh.

[former_member186316]

Hi Ramesh ,

There is a problem in dictionary object /B28/YFBD2JTI, activate that dictionary object , it  may resolve

ABAP dump.

Hope this helps

[former_member190501]

Hi,

Can you check the status of object /B28/YFBD2JTI.

This will be the Data element of /CPMB/*BD2JTI

Thanks,

Raju