Maintain scrn layout rule for dep.area 20 + asset class C2000 or deactiv. it

[former_member597074]

Hi i m encountering this error while doing asset class configuration .please help me.i have attached the screen shot of the same .

[joseluis_carbajo · Accepted solution]

Hi Jithin,

Believe you receive the error AA630.

In general this error is commonly known to appear if you try to
maintain and save customizing concerning transaction OAYZ. The system
checks the consistency of ALL asset classes. Please review table ANKB
to make sure that ALL asset classes in your system have a screen layout
rule assigned.

However, I think in your case maybe you should follow the recommendation
where a customer did not use the asset class in error but had to create
the asset class again to bring ANKA and ANKB in line. After that you
will be able to determine depreciation areas to the required asset class.

So, it could be that maybe this asset class at one point did exist and
that someone tried to delete it and the asset class is listed in one
of these tables ANKA and ANKB or part of the asset class is.

Though, I must advise you that asset classes - entries in the tables
ANKB and ANKA, or in V_ANKB_XSPEB can not be deleted.
You can lock in transaction AM05 any asset class. If an asset class is
locked via AM05, it no longer appears in the F1 help in AS01.

I would recommend to align tables ANKA and ANKB again, and
then check if you want to lock asset class C2000 altogether.

Please also review note 39159 "ANKB entries without ANKA entries"
which might help you to resolve this issue.

I hope you find this information helpful.
Jose Luis Carbajo

[former_member597074 · Accepted solution]

Thank u jose luis

[Former Member]

Hi Jithin,

Please copy screen layout rule from the Standard one then assign it to asset class. It will work.

Regards,

Prakash Kumar

[former_member597074]

Thank u prakash  ...let me try that also

...