Skip to Content

How to control custom message in GTS to trigger only one custom message

Hi All,

Hope you all are doing well!!

As per my requirement, we have created two custom messages in GTS but we need to trigger only one output at a time based on access sequence maintained in defaulting data. This means that system should stop looking for another messages if already one message is found based on access sequence. For such requirement in ECC, we do have Exclusive Indicator for system to stop searching for a record after the first successful access sequence. I am looking for such settings in GTS. Please help

Regards,

Alok Kumar

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

0 Answers