Regarding Crystal report parameter from and to.

[Former Member]

hi.

I am having one requirement ie.

Normally we are giving..i.e

We are using parameter in Sap b1 like Docentry

Based on this one Docentry the data will fetch from the data base and it will shows into the sap crystal reprot

suppose Ex Docentry = 3 then it will show the data.. then

but ring now what i nee dis  Docentry from and to

fromdocentry = 1

todocentry  = 5

so, 1,2,3,4,5 five documents should be generate one by one in crystal report in single crystal report not 5 pdf files single pdf should have 5 doc entries

Is it possible how can i do it.

how can i do it...

[julie_jamieson2]

Try changing the parameter type to allow Range to see what that does. I haven't tried this with the SAP SP tokens.

You may need to create your own, as this will run as a report, not a layout?

[Former Member]

I got the solution...

At new page before i put  the code...pagenumber = totalpagecount

at new page after i put the code. ...pagenumber =1

[former_member188586]

Hi

$riniva$ Rachumallu

please Follow above image steps, you get the Out put..

  Thanks Regards

     Andakondaramudu

[former_member205766]

Hi

I think it is not possible from Crystal Report but below discussion indicates it is possible through some Crystal Report SDK tool.

With Regards

Balaji Sampath

[kothandaraman_nagarajan]

Hi,

I don't think it is possible.

Thanks & Regards,

Nagarajan

[Former Member]

I seen some where...but i dont know how....