Skip to Content

Issue with WDDOEXIT

Hi All I am updating a custom table in view  WDDOEXIT method for one of the requirements . When I logged off or refresh the Url in dev system WDDOEXIT immediately . But in quality system it is taking time to trigger the WDDOEXIT method .So my custom table is not getting updated and i should display custom table values navigating onto other view . Because of not updating custom table i am not able to pull data from same. Any clues if some one had faced this issue . Thanks Kamesh

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Jul 31, 2014 at 07:01 AM

    Hi Kamesh,

    I wonder about this strange behavior.

    But WDDOEXIT will always trigger immediately after the source code during exit of the application.

    So in your condition, please check your source coding and also make sure that you are not using any time delay for your application.

    BR,

    RAM.

    Add comment
    10|10000 characters needed characters exceeded

  • Jul 31, 2014 at 05:44 AM

    Hi Kamesh,

    But in quality system it is taking time to trigger the WDDOEXIT method

    is WDDOEXIT method getting triggered after long time? if so, still your code gets through right?


    Could you elaborate the requirement in detail?


    Regards,

    Rama

    Add comment
    10|10000 characters needed characters exceeded