Skip to Content
author's profile photo Former Member
Former Member

Invoice Verification tolerance price varience

Hi All,

I have set Invoice verification tolerance key PP upper limit 5 % and value 5 in customizing.

I have also set message M8082 and M8083 as error message in customizing.

My requirement is to limit user from posting invoice above 5 % of GRN Amount.

The message customizing is working fine for value (M8082) however I cannot get message M8083 for % of invoice amount tolerance.

I want message M8083 to be triggered at invoice verification which is not happening.

Add a comment
10|10000 characters needed characters exceeded

Related questions

3 Answers

  • Best Answer
    author's profile photo Former Member
    Former Member
    Posted on Jul 24, 2014 at 02:59 AM

    Hi,

    If the price in an order item is marked as an estimated price, for this item, the system calculates the difference between the invoice value and the product of quantity invoiced * order price and compares the variance with the upper and lower tolerance limits defined

    Please confirm your PO should have following check on condition control tab

    and maintain the Tolerance key PS for upper and lower % limits, system first go through Val. check and then % tolerance limit check,

    then you will get the message M8083


    Sohaib Mahmood wrote:

    My requirement is to limit user from posting invoice above 5 % of GRN Amount.

    The message customizing is working fine for value (M8082) however I cannot get message M8083 for % of invoice amount tolerance.

    I want message M8083 to be triggered at invoice verification which is not happening.


    if you want to limit the user from posting the invoice by 5% tolerance, then maintain PP tolerance key,

    you will get the message M8082 this will solve your purpose,

    If your business demand for estimated price variance then maintain PS tolerance key you will get the message M8083

    Thanks


    Message was edited by: k j


    po.jpg (31.4 kB)
    ps.jpg (51.7 kB)
    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Jul 23, 2014 at 12:39 PM

    Did you maintained in OMR6 for tolerance key PS also?

    Add a comment
    10|10000 characters needed characters exceeded

  • Posted on Jul 23, 2014 at 12:54 PM

    Hi,

    The absolute upper limit for tolerance key PP will trigger M8 082 and the percentage upper limit will trigger M8 083. Please check the screenshot below:

    Please maintain the same in OMR6 for tolerance key PP and test the scenario again and revert back.

    Regards,

    AKPT


    pastedImage_0.png (26.0 kB)
    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.