Skip to Content
author's profile photo Former Member
Former Member

BODS SFDC Adapter issue while reading/loading data: Could not read data for session 776, operation 773 (Adapter: 'SFDC').>.


Hi,

I have a job that reads data from SFDC. We are using SFDC adapter. I am getting following error in Management console:

Error reading from <QRY_SFDC>: <

Could not read data for session 776, operation 773 (Adapter: 'SFDC').>.

But when I re run the job, it gets executed successfully.

I have referred note 2034822, which says:

From 4.1 SP3 and 4.2 following parameters are missing or not set correctly in
%DS_COMMON_DIR%\conf\DSConfig.txt under [int] section

AdapterStartTimeout=90000
AdapterDataExchangeTimeout=10800000

I have DS v 4.0.

In DSCOnfig.txt following values are there:

AdapterRetryCount = 5

AdapterRetryInterval = 15000

AdapterDataExchangeTimeout = 90000.

and there is no entry for AdapterStartTimeout.

Is this note applicable for DS v4.0 also. If I change the parameter values and add the entry AdapterStartTimeout=90000, will it solve my error?

(Note: sometimes , I also get this error in another job which loads data to SFDC)

Thanks in advance.

Add a comment
10|10000 characters needed characters exceeded

Assigned Tags

Related questions

1 Answer

  • Best Answer
    author's profile photo Former Member
    Former Member
    Posted on Jul 16, 2014 at 04:31 PM

    The error says could not read the sessions, so it has some thing to do with the adpater exchange. Increase only the AdapterDataExchangeTimeout=10800000.

    Add a comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi,

      If i remember correctly, you can set the adapter configuration values by editing the adapter configuration from designer. I don't have a SFDC adapter handy right now so could not verify it.

      Secondly if the job is not erroring out always then most likely it would be a network congestion or time out issue only. Since you have already done changing the AdapterStartTimeout and AdapterDataExchangeTimeout values in DSConfig.txt, and the issue is not rectified i would recommend raise a ticket with SAP.

      Arun

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.