on 06-23-2014 2:10 PM
When I had cifed the Production Order, it returns the message "sequence-dependent setup activity does not have a mode".
In CIF reconcilation it comes under missing in APO log.
This is not consistent.Some order gets cifd without any issues.Some are having this issue.
Anywhere I m missing.
HI Roshan,
You are using PDS or PPM to model your production versions in APO? If you use PPM, check if you have only one setup activity and if that activity have the setup checkbox marked.
All the problematic orders have the same material? Did you check if the PDS or PPM was correctly transferred to APO? You have this problem only with production order and not with planned orders?
Are you using sequence-dependant setupo matrix?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Kindly check the below steps:
1) Check if the note 863509 is imeplemented in your system, and very importantly the exit is implemented properly and activated so that it is called during the order transfer
2)In case you have a scenario where a new material is added during production then in that case that material needs to be assigned to an activity, it shouldnt have an dummy acitivity.
BR
Gomathi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Kindly check if "determine capacity reqrements" is set for the order, Because most of the times this issue occurs due to no generation of capacity requirements.
Hope this helps
BR
Gomathi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
13 | |
4 | |
3 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.