Skip to Content

SPC ERROR

I am getting the below ERROR when trying to RUN the SPC display using SAP
MEv15 -

What could be the reason ?

Thx

SPC ERROR.jpg (12.7 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    Jun 23, 2014 at 05:38 AM

    Hi,

    Please get the full java stack trace for this issue from defaultTrace log. It might be the case when SAP ME just displays an error thrown by MII.

    Possibly you should double-check section 5.1.2 of the How-To Guide where MIICatalog_HTTP needs to be setup.

    Regards,

    Sergiy

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 12, 2016 at 06:23 AM

    I am getting same error while using SPC Display in SAP ME in 15.0.3 version. Our MII version is 15.0.4 and i have made sure all the components of MII applications are up. But still i am seeing the problem.

    Any suggestion?

    HTTP transport failed using HTTP destination MIICatalog_HTTP (Message 19913)

    Add comment
    10|10000 characters needed characters exceeded

    • Hi!

      1. Have you fully executed the instructions on how to set up SPC with MII, as described in the ME Installation Guide? I would recommend that you follow the steps once again to check them.

      2. Have you tried start-stop? Stop me~ear, then stop both applications of MII, start me~ear, and when ME is fully started, start both MII applications.

      Regards,

      Sergiy

  • avatar image
    Former Member
    Feb 12, 2016 at 09:18 AM

    Thanks Serigy. HTTP destination MIICatalog_HTTP was missing in my config. it is working now.

    Thannk you.

    Adarsha.K.S

    Add comment
    10|10000 characters needed characters exceeded