Skip to Content
avatar image
Former Member

PI 7.1(dual stack) and PI 7.31(Single stack) -

Friends,

I have a proxy to proxy scenario - Proxy --> PI --> Proxy

We have two servers PI 7.1(dual stack) and PI 7.31(Single stack)

i did the development in ESR and my ESR is pointing to PI 7.1, when i execute the scenario i receive one error message "receiver could not be determined", i ensured that all my input is correct, still i get the same error message.

the expectation is my scenario should point to PI 7.31, Can some one help me where and what settings i need to make in-order to make it work.

Please Note: All my data is correct and i read some scn forums wherein they asked to refresh the cache , i have refreshed the cache also still the problem persists.

Thanks in advance!

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Jun 20, 2014 at 06:06 AM

    Hi Jitesh,

    Have you checked the communication component in ID is the same that in sender side in the sxi_monitor?

    could you share your sender configuration and the sxi_monitor?

    Regards.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jun 20, 2014 at 06:17 AM

    Hi Jitesh,

    I can say problem is not with the input Data, problem is with "Receiver Determination" step in Integration Directory (ID). Check whether it is properly defined as per the requirement or not.

    Regards,

    Krupa

    .

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jun 20, 2014 at 06:42 AM

    Iñaki Vila


    Communication component in ID is the same as sender side.


    could you share your sender configuration?

    Did you mean Tcode - SXMB_ADM and under that Sender/Receiver configuration



    Krupa Rao Atluri

    In ID steps are correctly defined.

    I spoke to my colleague he hinted that at RUN TIME we want to point to PI7.31, he mentioned config change needed in SXMB_ADM

    any further inputs from any one could be useful.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Jitesh,

      What I feel is nothing to do with the SXMB_ADM.

      Are you getting this error in ECC or PI? Could you share the screen shot of error message and interface details sender component, receiver component, sender interface and receiver interface.  Also share the failed message screen shot in SXMB_MONI.

      Regards,

      Krupa