cancel
Showing results for 
Search instead for 
Did you mean: 

Error entry no. 20 No clock-out entry

Former Member
0 Kudos


Hi Expert,

We are implementing Positive time evaluation.while running the PT60 system giving the error "

"Error entry no. 20 No clock-out entry

29.03.2013 Processing terminated for EE 00007266 DHATCHANAMOORTHY YUVARAJA".Bcz of clock out entry is missing in on the particular date.

Here the employee worked on night shift.His clock in time is (TP10) on 29.03.2013 at 22:00 PM  and clock out(TP20) on 30.03.2013 at 06:00 AM.

While Generating Quota system throwing the above error.

Could you please suggest any body how to resolve this issue.

Thanks in Advance

M.Basha

Accepted Solutions (0)

Answers (3)

Answers (3)

vianshu
Active Contributor
0 Kudos

Can you please share the error screenshot?

What was the time pair which was formed?

Thanks and regards,

Vivek Barnwal

Former Member
0 Kudos

Hi Vivek,

Please check the error screenshot.

Regrads,

M.Basha

vianshu
Active Contributor
0 Kudos

Hi Basha,

This is happening because reaction indicator is blank for PDC Processing Status C11.

Please refer to PDC Processing Status Scenario 4: Reaction indicator is blank for PDC Processing Status C11 in my document below:

You can ensure creation of incomplete time pairs by the logic mentioned in my document.

Thanks and regards,

Vivek Barnwal

vianshu
Active Contributor
0 Kudos

Can you please share the error screenshot?

What was the time pair which was formed?

Thanks and regards,

Vivek Barnwal

former_member193652
Active Contributor
0 Kudos

Hi,

Are you generating quota by schema and you mean when you run time evaluation system shows the error?

In fact for such a shifts which are start from current day and finish next day you should check why system can't understand clock-out is blong to previous day?

You can fix it manually in PA30 or PA61. Open IT2011 and change day assignment "Assignment to previous day (set manually)" (minus character). By this you can fix this case but as I said to fix it for good you should chck your customizing.

For more information have a look at my replies at

http://scn.sap.com/thread/3385975

http://scn.sap.com/message/14176029

Regards,

Omid

Former Member
0 Kudos


Hi Omid,

I understood u r solution.i hv one question.is there only solution to assign the day assignment in IT2011 manually .if the same issue raises for more than one employee what we hv to do?

Regards,

M.Basha